Autoclear CC-820 4:1
Description
| 4 CC-820 4: 1 1 H-230 4: 1 Hardener |
| Spray gun set-up: 1.2-1.5 mm Application pressure: 1.7-2.2 bar at the air inlet /HVLP max 0.6-0.7 bar at the air cap |
| 2 x 1 coat |
| Between coats Before curing 5-7 minutes at 20°C 5-7 minutes at 20°C |
| 20 hours at 20°C 30 minutes at 60°C |
| Use suitable respiratory protection |
CC-820 - CLEAR COAT 4:1
Description: Autoclear 4:1 is a fast drying urethane clear which can be used for spot -, panel repair and overall refinishing in
combination with Autobase at a temperature range from 25° – 35° C. Autoclear 4:1 is supplied as a set with its
own hardener. No extra thinner is needed to get optimum gloss and flow. With care, Autoclear 4:1 can be
polished within 3 hours at 30° C.
Product and additives:
Hardener Autoclear 4:1 Hardener
Basic raw materials:
Autoclear 4:1 : acrylic resins
Autoclear Hardener 4:1 : polyisocyanate resins
Suitable substrates:
To be applied over feargus
| 4:1 Autoclear 4:1 Autoclear 4:1 Hardener |
| 16 -17 seconds – DIN Cup 4 at 20°C |
| Spray gun Fluid tip – set-up Application pressure Gravity feed 1.2-1.5 mm 1.7-2.2 bar at the spray gun air inlet HVLP max 0.6-0.7 bar at the air cap |
| Apply 2 single flowing coats, allowing for a flash-off time of 5-7 minutes between coats.
The first coat should be applied with sufficient flow, but should not be too heavy.
After flash-off time, apply the second coat.
Lettering: Within 24 hours, Autocryl can be applied directly to Autoclear 4:1. After this 24 hourperiod, scuffing with Scoth Brite Type S Ultra Fine is required. |
